One of the notable change is that previously test-sysusers.sh was installed
unconditionally, but now it is installed only when sysusers is enabled.
Another change is that test-sysv-generator is now re-introduced which
was mistakenly dropped by 6c713961ab.
Decrease devlink priority for encrypted partitions, and make the priority for
decrypted DM devices relatively higher. This is for the case that an encrypted
partition and its decrypted DM device have the same label.
Fixes
| ../git/src/basic/user-util.c:708:30: error: use of undeclared identifier 'LOCK_EX'; did you mean 'LOCK_BSD'?
| 708 | r = unposix_lock(fd, LOCK_EX);
| | ^~~~~~~
| | LOCK_BSD
Signed-off-by: Khem Raj <raj.khem@gmail.com>
This is clearly a change that can break existing units, and broke my
system in at least two different ways. For this reason this should have
been added to NEWS in #26458, specifically c2da3bf, but wasn't.
Otherwise, it also matches later created virtual devices, and that
breaks networks generated and managed by container management services,
like docker.
Closes#28626.
We were passing the dir handle for the ESP to
config_entry_bump_counters(), which will obviously fail if the entry
actually resides on the XBOOTLDR partition.
Fixes: #28637
$ journalctl -u systemd-bless-boot.service
systemd[1]: Starting Mark the Current Boot Loader Entry as Good...
systemd-bless-boot[536]: Marked boot as 'good'. (Boot attempt counter is at 2.)
systemd-bless-boot[536]: Can't find boot counter source file for '/loader/entries/arch.conf': Device or resource busy
systemd[1]: Finished Mark the Current Boot Loader Entry as Good.
We were running systemd-measure before adding the sbat section,
let's fix that.
Also make sure we only pass --linux to systemd-measure once instead
of twice.
Previously, we first generate names based on the PCI slot and ACPI
onboard index, and then append an identifier based on USB or BCMA bus
if it exists in between the PCI bus and the interface.
However, if there exists USB or BCMA bus, the name based on the
ACPI onboard index is not used.
So, let's invert the order; first generate USB or BCMA identifier if the
bus exists, then prepend the name with the PCI slot identifier.
With this change, we can drop Names struct, and each naming logic
becomes self-consistent.
Then call it only when it is necessary. The label is used only when the
interface is directly connected to the PCI bus, and it does not have the
SR-IOV feature (or the naming based on SR-IOV is disabled).
This contains redundant copy of BCMA identifier, but that will be
dropped in the next commit.
No functional change, just refactoring and preparation for later
commits.
This contains redundant copy of USB identifier, but that will be
dropped in the next commit.
No functional change, just refactoring and preparation for later
commits.
