- Updated firmware to latest release (v3.4.8) to fix TSO + jumbo frame lockup
- Added MSI (hw.bce.msi_enable) and TSO (hw.bce.tso_enable) sysctls
- Fixed kernel panic when MSI is used and module is unloaded
- Added several new debug routines
- Removed slack space for RX/TX chains since it only covers sloppy coding
- Fixed a potential problem when programming jumbo MTU size in hardware
- Various other comment changes
MFC after: 4 weeks
because on at least my dc based cards there's garbage in there. The
recent changes in the resource code appears to have unmasked this
problem... At least dc now probes/attaches better than it did before.
Also, we no longer need to write to the cfg for the other registers.
legacy codepath match the 82575, without this we were seeing bridging
fail on 82546 adapters. Secondly, I have limited TSO to PCI Express
adapters, I meant to do this and it got dropped in the earlier delta.
Next, I am dropping in the latest shared code from our development
team, consensus was that this should be done frequently, so I am :)
Approved by: pdeuskar
This patch does the following:
- Remove un-necessary code that is not even compiling into the driver
under TW_OSL_NON_DMA_MEM_ALLOC_PER_REQUEST defines.
- Remove bundled firmware image and associated "files" entry for tw_cl_fwimg.c
- Remove bundled firmware flashing routines. We now have tw_update userspace
FreeBSD controller flash utility.
- Fix driver crash on load due to shared interrupt.
- Fix 2 lock leaks for Giant lock.
- Fix CCB leak.
- Add support for 9650SE controllers.
Many thanks to 3Ware/AMCC for continuing to support FreeBSD.
time workaround for problems with 82571 adapters and LAAs, one port
getting reset can cause the other to have its RAR[0] also reset,
thus overwriting an LAA. This fix works around it by also keeping
the address in the last array member.
The other bug is specific to the new 575 adapter, its transmit code
logic in handling hwassists was too crude, it broken when doing
bridges. I am much happier with the new logic,we may want to change
the legacy path at some point to something similar.
Reviewed by: pdeuskar
Approved by: pdeuskar
- Update to latest (1.4.17) firmware.
- Use the new MXGEFW_CMD_UNALIGNED_TEST (added in firmare 1.4.16) to
have the firmware tell us if the PCIe chipset supports aligned PCIe
completions.
- Hard to maintain, and frequently out of date whitelist of PCIe
chipsets known to produce aligned completions removed, as it has been
replaced in its role of selecting the correct firmware to run by the
use of MXGEFW_CMD_UNALIGNED_TEST.
- Break the dma test out of mxge_reset() and into its own function
(mxge_dma_test()) so it can be used by both the normal DMA test, and
to run the unaligned test.
- Improved support for enabling ECRCs
Sponsored by: Myricom Inc.
Seems to work on RELENG_4 through -current and also on sparc64
now. There may still be some issues with the auto attach/detach
code to sort out.
MFC after: 3 days
- http://www.intel.com/design/chipsets/specupdt/245051.htm
AC97 Soft Audio and Soft Modem Master Abort Errata
Issue:
Use of either soft audio or soft modem on an Intel® 82443MX PCISet
based platform running a 100 MHz Processor System Bus and an AC97 codec
may result in failures. The system continues to function normally while
the AC97 hardware may not resume and may require a cold-boot to
recover. As a result of the failure, the Master Abort Status bit will
be set in the audio or modem function PCI header space.
Workaround:
Force uncacheable DMA on both BDL and pcm buffers.
Tested by: Emil Holmstr|m <emil@linux.se>
- Remove explicit call to pmap_change_attr(), since we now have proper
and functional definition of BUS_DMA_NOCACHE.
- Enable PCI(e) bus snooping for non i386/amd64 as an alternative for
uncacheable DMA.
- Codecs changes:
* Analag Device -> Analog Devices, AD1988.
* New codec: VIA VT1708 and VT1709, Realtek ALC262, ALC861-VD and
ALC885.
* Various fixups for Conexant Waikiki, fix recording (read: microphone)
on various Analog Devices codecs due to vendor BIOS mess, various
quirks for several ASUS laptops/boards.
- Fix connection list handling, closely following the specification to
handle range of nids.
- Basic Jack sense polling infrastructure for possible hardwares with
broken unsolicited response interrupt.
Ideas/Submitted/Tested by: Andriy Gapon <avg@icyb.net.ua>,
#freebsd-azalia, many.
Updated copyright date to 2007.
Tested with BCM5706 A3.
Added ID for BCM5708 B2.
Removed unused driver version string.
Modified BCE_PRINTF macro to automatically fill-in the sc pointer.
Fixed a kernel panic when the driver was loaded as a module from the
command-line because the MII bus pointer was null (i.e. the MII bus
hadn't been enumerated yet).
Added fix proposed by Vladimir Ivanov <wawa@yandex-team.ru> to prevent
driver state corruption when releasing the lock during the ISR in
bce_rx_intr() to send packets up the stack.
Added new TX chain and register read sysctl interfaces for debugging.
Cleaned up formatting for various other debug routines.
Added a new statistic maintained by firmware which tracks the number
of received packets dropped because no receive buffers are available.
correct network drivers with respect to busmaster DMA, go over it
with at duster to make other aspects of it a role model:
Eliminate the pci specific softc, it serves no rational purpose.
Use convenience resource allocation/deallocation functions to save
code and errorhandling.
Switch from bus_space_{read|write}_%u() to bus_{read|write}_%u()
functions and forget about tags and handles, the resource will know
about those, should they be needed. This also eliminates a number
of inconsistently named local variables.
in comments for .c and .h files respectively. Jack may want to clean up
style or other aspects once he's up and about again, but this gets the
kernel compiling.