report the actual number of RPCs issued, not the theoretical number
that would be issued if all caching was disabled.
Reviewed by: rmacklem
MFC after: 2 weeks
- Similar to the hack for bootinfo32.c in userboot, define
_MACHINE_ELF_WANT_32BIT in the load_elf32 file handlers in userboot.
This allows userboot to load 32-bit kernels and modules.
- Copy the SMAP generation code out of bootinfo64.c and into its own
file so it can be shared with bootinfo32.c to pass an SMAP to the i386
kernel.
- Use uint32_t instead of u_long when aligning module metadata in
bootinfo32.c in userboot, as otherwise the metadata used 64-bit
alignment which corrupted the layout.
- Populate the basemem and extmem members of the bootinfo struct passed
to 32-bit kernels.
- Fix the 32-bit stack in userboot to start at the top of the stack
instead of the bottom so that there is room to grow before the
kernel switches to its own stack.
- Push a fake return address onto the 32-bit stack in addition to the
arguments normally passed to exec() in the loader. This return
address is needed to convince recover_bootinfo() in the 32-bit
locore code that it is being invoked from a "new" boot block.
- Add a routine to libvmmapi to setup a 32-bit flat mode register state
including a GDT and TSS that is able to start the i386 kernel and
update bhyveload to use it when booting an i386 kernel.
- Use the guest register state to determine the CPU's current instruction
mode (32-bit vs 64-bit) and paging mode (flat, 32-bit, PAE, or long
mode) in the instruction emulation code. Update the gla2gpa() routine
used when fetching instructions to handle flat mode, 32-bit paging, and
PAE paging in addition to long mode paging. Don't look for a REX
prefix when the CPU is in 32-bit mode, and use the detected mode to
enable the existing 32-bit mode code when decoding the mod r/m byte.
Reviewed by: grehan, neel
MFC after: 1 month
network packets that we parse and not against local users trying to gain root
access through ping's set-uid bit - this is handled by dropping privileges very
early in ping.
Submitted by: Mikhail <mp@lenta.ru>
only if the specified option is NOT specified.' Bump version because
old config won't be able to cope with files* files that have this
construct in them.
allow mrsas(4) from LSI to attach to newer LSI cards that are support by
mrsas(4). If mrsas(4) is not loaded into the system at boot then mfi(4)
will always attach. If a modified mrsas(4) is loaded in the system. That
modification is return "-30" in it's probe since that is between
BUS_PROBE_DEFAULT and BUS_PROBE_LOW_PRIORITY.
This option is controller by a new probe flag "MFI_FLAGS_MRSAS" in mfi_ident
that denotes cards that should work with mrsas(4). New entries that should
have this option.
This is the first step to get mrsas(4) checked into FreeBSD and to avoid
collision with people that use mrsas(4) from LSI. Since mfi(4) takes
priority, then mrsas(4) users need to rebuild GENERIC. Using the
.disabled="1" method doesn't work since that blocks attaching and the
probe gave it to mfi(4).
Discussed with: LSI (Kashyap Desai)
* The RFC says (in section 10.1) that only when extbuf is not NULL,
extlen shall be checked, so don't perform this check when NULL is
passed.
* socklen_t is unsigned, so checking extlen for less than zero is
not needed.
Submitted by: swildner@dragonflybsd.org
Reviewed by: Mark Martinec <Mark.Martinec+freebsd@ijs.si>
Reviewed by: hrs
Obtained by: DragonFlyBSD
Prior to this change the cached value of 'pm_eptgen' was tracked per-vcpu
and per-hostcpu. In the degenerate case where 'N' vcpus were sharing
a single hostcpu this could result in 'N - 1' unnecessary TLB invalidations.
Since an 'invept' invalidates mappings for all VPIDs the first 'invept'
is sufficient.
Fix this by moving the 'eptgen[MAXCPU]' array from 'vmxctx' to 'struct vmx'.
If it is known that an 'invept' is going to be done before entering the
guest then it is safe to skip the 'invvpid'. The stat VPU_INVVPID_SAVED
counts the number of 'invvpid' invalidations that were avoided because
they were subsumed by an 'invept'.
Discussed with: grehan
did this only with the inner loop for the token parsing, and not the
outer loop which was understandable enough when the extra layers of
looping went away...
the output buffer wasn't being cleared between the inflate() calls,
producing zeroed output after the first inflate() call.
This fixes the read of mkuzip(8) images with geom_uncompress(4).
Reviewed by: ray
Approved by: adrian (mentor)
its proper location. Otherwise you could have 'file.c standard pci'
without an error. This construct isn't in our tree, and has no well
defined meaning.
performance by epsilon.
(Translation: elminate bogus macros that hid 'returns' making it hard
to read and moved a block of code inline rather than at the end of the
fuction where it was effectively a 'gosub' kind of goto).
parsing YAML tags.
Also apply a patch for hardenning the guards againt the issue
The only user in base in yaml is pkg(7) which uses the library a way that it is not affected
Submitted by: delphij
Obtained from: https://bugzilla.redhat.com/show_bug.cgi?id=1033990
MFC after: 3 days
Security: CVE-2013-6393
parsing YAML tags.
Also apply a patch for hardenning the guards againt the issue
The only user in base in yaml is pkg(7) which uses the library a way that it is not affected
Submitted by: delphij
Obtained from: https://bugzilla.redhat.com/show_bug.cgi?id=1033990
Security: CVE-2013-6393
