These are included unconditionally for now because bsdconfig
is currently installed unconditionally.
This fixes 'make -j 17 installworld' caused by a race
condition.
MFC candidate.
- Remove excessive parenthesis
- Use KNF continuation indentation
- Cut down on excessive continuation lines
- More consistent style in messages
- Use uprintf() instead of printf()
Submitted by: bde
calls ns8250_bus_ipend() almost immediately after ns8250_bus_attach().
As it appears, a line break condition is being signalled for almost
all received characters due to this. A delay of 150ms seems enough
to allow the H/W to settle and to avoid the problem.
More analysis is needed, but for now a regression has been addressed.
Reported by: kevlo@
Tested by: kevlo@
MADV_DONTNEED) and madvise(..., MADV_FREE). Specifically, introduce a new
pmap function, pmap_advise(), that operates on a range of virtual addresses
within the specified pmap, allowing for a more efficient implementation of
MADV_DONTNEED and MADV_FREE. Previously, the implementation of
MADV_DONTNEED and MADV_FREE relied on per-page pmap operations, such as
pmap_clear_reference(). Intuitively, the problem with this implementation
is that the pmap-level locks are acquired and released and the page table
traversed repeatedly, once for each resident page in the range
that was specified to madvise(2). A more subtle flaw with the previous
implementation is that pmap_clear_reference() would clear the reference bit
on all mappings to the specified page, not just the mapping in the range
specified to madvise(2).
Since our malloc(3) makes heavy use of madvise(2), this change can have a
measureable impact. For example, the system time for completing a parallel
"buildworld" on a 6-core amd64 machine was reduced by about 1.5% to 2.0%.
Note: This change only contains pmap_advise() implementations for a subset
of our supported architectures. I will commit implementations for the
remaining architectures after further testing. For now, a stub function is
sufficient because of the advisory nature of pmap_advise().
Discussed with: jeff, jhb, kib
Tested by: pho (i386), marcel (ia64)
Sponsored by: EMC / Isilon Storage Division
(re)start the interface when it is down. This change fix a race with
BOOTP where the response packet is lost because the interface is being
reset by a netmask change right after send the packet.
PR: 178318
Approved by: adrian (mentor)
As promised, drop the option to make the older GNU patch
the default.
GNU patch is still being built but something drastic may
happen to it to it before Release.
Add a last-modified timestamp to each LRO entry and provide an interface
to flush all inactive entries. Drivers decide when to flush and what
the inactivity threshold should be.
Network drivers that process an rx queue to completion can enter a
livelock type situation when the rate at which packets are received
reaches equilibrium with the rate at which the rx thread is processing
them. When this happens the final LRO flush (normally when the rx
routine is done) does not occur. Pure ACKs and segments with total
payload < 64K can get stuck in an LRO entry. Symptoms are that TCP
tx-mostly connections' performance falls off a cliff during heavy,
unrelated rx on the interface.
Flushing only inactive LRO entries works better than any of these
alternates that I tried:
- don't LRO pure ACKs
- flush _all_ LRO entries periodically (every 'x' microseconds or every
'y' descriptors)
- stop rx processing in the driver periodically and schedule remaining
work for later.
Reviewed by: andre
UF_SYSTEM, UF_SPARSE, UF_OFFLINE, UF_REPARSE, UF_ARCHIVE, UF_READONLY,
and UF_HIDDEN.
Sort the file flags tmpfs supports alphabetically. tmpfs now
supports the same flags as UFS, with the exception of SF_SNAPSHOT.
Reported by: bdrewery, antoine
Sponsored by: Spectra Logic
- tom_uninit had to be reworked not to hold the adapter lock (a mutex)
around t4_deactivate_uld, which acquires the uld_list_lock.
- the ifc_match for the interface cloner that creates the tracer ifnet
had to be reworked as the kernel calls ifc_match with the global
if_cloners_mtx held.
allocations under low free-space conditions (-r254995), determine
that old block-preference search order used before -r249782 worked
a bit better. This change reverts to that block-preference search order.
MFC after: 2 weeks
I have 25TB Dell PERC 6 RAID5 array. When it becomes almost
full (10-20GB free), processes which write data to it start
eating 100% CPU and write speed drops below 1MB/sec (normally
to gives 400MB/sec). The revision at which it first became
apparent was http://svnweb.freebsd.org/changeset/base/249782.
The offending change reserved an area in each cylinder group to
store metadata. The new algorithm attempts to save this area for
metadata and allows its use for non-metadata only after all the
data areas have been exhausted. The size of the reserved area
defaults to half of minfree, so the filesystem reports full before
the data area can completely fill. However, in this report, the
filesystem has had minfree reduced to 1% thus forcing the metadata
area to be used for data. As the filesystem approached full, it
had only metadata areas left to allocate. The result was that
every block allocation had to scan summary data for 30,000 cylinder
groups before falling back to searching up to 30,000 metadata areas.
The fix is to give up on saving the metadata areas once the free
space reserve drops below 2%. The effect of this change is to use
the old algorithm of just accepting the first available block that
we find. Since most filesystems use the default 5% minfree, this
will have no effect on their operation. For those that want to push
to the limit, they will get their crappy block placements quickly.
Submitted by: Dmitry Sivachenko
Fix Tested by: Dmitry Sivachenko
PR: kern/181226
MFC after: 2 weeks
If we panic again shortly after boot (say, within 30 seconds), any core
dump we wrote out may be lost on reboot. In this situation, we really
want to keep that core file, as it may be the only way to have the issue
resolved. Call sync(8) after writing out the core file and running
crashinfo(8), in the hope that these will not be lost if we panic
again. sync(8) is only called in the case where there is a core dump
to be written out, so won't be called during normal boots.
Discovered by: Trying to debug an IPSEC panic
MFC after: 1 week
the passed vnode belongs to the same mount point (v_vfsp or also
known as v_mount in FreeBSD). This check prevents the code from
proceeding further on vnodes that do not belong to ZFS, for
instance, on UFS or NULLFS.
The recent change (merged as r254585) on upstream changes the
check of v_vfsp to instead check the znode's z_zfsvfs. On Illumos
this would work because when the vnode comes from lofs, the
VOP_REALVP() would give the right vnode, this is not true on
FreeBSD where our VOP_REALVP is a no-op, and as such tdvp is
not guaranteed to be a ZFS vnode, and will later trigger a
failed assertion when verifying the vnode.
This changeset modifies our local shims (zfs_freebsd_rename and
zfs_freebsd_link) to check if v_mount matches before proceeding
further.
Reported by: many
Diagnostic work by: avg
This removes the WITH_BSDCONFIG description alltogether, since this option
is removed.
At the same time, fix the WITHOUT_LIBCPLUSPLUS option that had gotten
inverted.
