Direct kernel boot results in much faster boot times so let's use
it by default.
We disable it for tests that need to reboot because +-50% of the
time, doing a reboot when using direct kernel boot causes qemu to
hang on reboot. Until we figure that out, let's use UEFI for the
tests that need to reboot.
When we want to get an interactive shell in a test that fails because
of a race condition, we might need to run the test a few times with
--repeat before it fails. However, currently, when -i is used, the VM
needs to be shut down manually each time before the next run can start.
Let's always shut down the VM if the test succeeds so that --repeat can
be used with -i to run the test until it fails and then get an interactive
shell in the VM.
If we're not debugging tests, there's no point in persisting the journal,
so let's use the volatile journal storage mode in that case to avoid doing
unnecessary work.
We don't disable journal storage alltogether since various tests check
that stuff is written to the journal.
We cannot mark a test suite as excluded by default in meson. Instead,
let's require that SYSTEMD_INTEGRATION_TESTS=1 and skip any integration
test if it's not set. This is effectively the same as excluding it by
default. If the integration-test option is enabled, we'll set the
environment variable by default, just like we do with SYSTEMD_SLOW_TESTS
and the slow-tests meson option.
If an assert in systemd fails it can't shut down normally.
By default it freezes. For interactive runs we want the crash shell
to enable further debugging, but during test runs we want it to exit
without having to wait for the test timeout.
By deactivating the crash shell, enabling reboot, and configuring qemu
so that it shuts down instead of rebooting we can shut down instead.
Because by default UEFI will enroll keys and then reboot
we also have to set --qemu-firmware-variables=custom
so it doesn't need to auto-enroll.
Because mkosi has to handle not receiving an EXIT_STATUS notification
it falls back to the exit code of qemu, which in the case of reboot
would be 0, we also override the success exit status to 123
and check that we got that as an exit code from mkosi.
- Stop using logging module since the default output formatting is
pretty bad. Prefer print() for now.
- Log less, logging the full mkosi command line is rather verbose,
especially when it contains multi-line dropins.
- Streamline the journalctl command we output for debugging failed
tests.
- Don't force usage of the disk image format.
- Don't force running without unit tests.
- Don't force disabling RuntimeBuildSources.
- Update documentation to streamline the command for running a single
test and remove sudo as it's not required anymore.
- Improve the console output by having the test unit's output logged
to both the journal and the console.
- Disable journal console log forwarding as we have journal forwarding
as a better alternative.
- Delete existing journal file before running test.
- Delete journal files of succeeded tests to reduce disk usage.
- Rename system_mkosi target to just mkosi
- Pass in mkosi source directory explicitly to accomodate arbitrary
build directory locations.
- Add test interactive debugging if stdout is connected to a tty
- Stop explicitly using the 'system' image since it'll likely be
dropped soon.
- Only forward journal if we're not running in debugging mode.
- Stop using testsuite.target and instead just add the necessary
extras to the main testsuite unit via the credential dropin.
- Override type to idle so test output is not interleaved with
status output.
- Don't build mkosi target by default
- Always add the mkosi target if mkosi is found
- Remove dependency of the integration tests on the mkosi target
as otherwise the image is always built, even though we configure
it to not be built by default.
- Move mkosi output, cache and build directory into build/ so that
invocations from meson and regular invocations share the same
directories.
- Various aesthetic cleanups.
