Due to the bug in kernel 6.9 caused by
8debcf5832,
the net_id udev builtin does not work for netdevsim interface.
So, eni99np1 cannot be used with kernel 6.9 anymore.
Workaround for #32910.
Previously, one of the test route has the same address in destination
and gateway. Even it is a test case, that's super spurious. Let's use a
different address.
This deprecates IPForward= setting, which unconditionally controled
the global setting, even though it is a setting in .network file.
Instead, this introduces new IPv4Forwarding= and IPv6Forwarding=
settings both in .network and networkd.conf.
If these settings are specified in a .network file, then the
per-interface forwarding setting will be configured.
If specified in networkd.conf, then the global IP forwarding setting will
be configured.
Closes#30648.
The RA's Retransmission Timer field was being ignored. This resolves the IPv6
Core Conformance test, v6LC.2.1.5 [1].
Retransmission Timer is a 32-bit unsigned integer. The time, in milliseconds,
between retransmitted Neighbor Solicitation messages. Used by the Address
Resolution and Neighbor Unreachability Detection (NUD) algorithm.
Support setting a default value for the neighbour retransmission timer value with:
[Network]
IPv6RetransmissionTimeSec=<int>
By default, upon receiving a Router Advertisement with the Retransmission Timer
field set to a non-zero value, it will update the kernel's retransmit timer value.
To disable this behaviour, configure the UseIPv6RetransmissionTime= under the
[IPv6AcceptRA] section.
[IPv6AcceptRA]
UseIPv6RetransmissionTime=<bool>
RFC4861: Neighbor Discovery in IPv6
* Section 4.2 RA Message Format.
* Section 6.3.4 Processing Received Router Advertisements
A Router Advertisement field (e.g., Cur Hop Limit, Reachable Time,
and Retrans Timer) may contain a value denoting that it is
unspecified. In such cases, the parameter should be ignored and the
host should continue using whatever value it is already using. In
particular, a host MUST NOT interpret the unspecified value as
meaning change back to the default value that was in use before the
first Router Advertisement was received.
The RetransTimer variable SHOULD be copied from the Retrans Timer
field, if the received value is non-zero.
References
[1] IPv6 Core Conformance Spec (PDF)
We have not tested if the settings actually filter DHCP servers.
Let's add a test case for the settings.
Note, the .network file used here has been unused since
0730e3767d. So, we can freely reuse it
without changing other test cases.
Closes#30107.
