qemu/docs/specs/pci-testdev.txt
Gerd Hoffmann 417463341e pci-testdev: add optional memory bar
Add memory bar to pci-testdev.  Size is configurable using the membar
property.  Setting the size to zero (default) turns it off.  Can be used
to check whether guests handle large pci bars correctly.

Reviewed-by: Marc-André Lureau <marcandre.lureau@redhat.com>
Reviewed-by: Laszlo Ersek <lersek@redhat.com>
Tested-by: Laszlo Ersek <lersek@redhat.com>
Signed-off-by: Gerd Hoffmann <kraxel@redhat.com>
Reviewed-by: Michael S. Tsirkin <mst@redhat.com>
Signed-off-by: Michael S. Tsirkin <mst@redhat.com>
2018-11-05 13:24:02 -05:00

32 lines
1.4 KiB
Plaintext

pci-test is a device used for testing low level IO
device implements up to three BARs: BAR0, BAR1 and BAR2.
Each of BAR 0+1 can be memory or IO. Guests must detect
BAR types and act accordingly.
BAR 0+1 size is up to 4K bytes each.
BAR 0+1 starts with the following header:
typedef struct PCITestDevHdr {
uint8_t test; <- write-only, starts a given test number
uint8_t width_type; <- read-only, type and width of access for a given test.
1,2,4 for byte,word or long write.
any other value if test not supported on this BAR
uint8_t pad0[2];
uint32_t offset; <- read-only, offset in this BAR for a given test
uint32_t data; <- read-only, data to use for a given test
uint32_t count; <- for debugging. number of writes detected.
uint8_t name[]; <- for debugging. 0-terminated ASCII string.
} PCITestDevHdr;
All registers are little endian.
device is expected to always implement tests 0 to N on each BAR, and to add new
tests with higher numbers. In this way a guest can scan test numbers until it
detects an access type that it does not support on this BAR, then stop.
BAR2 is a 64bit memory bar, without backing storage. It is disabled
by default and can be enabled using the membar=<size> property. This
can be used to test whether guests handle pci bars of a specific
(possibly quite large) size correctly.