mirror of
https://github.com/torvalds/linux
synced 2024-10-26 13:19:27 +00:00
ff166cb57a
When interrupt-remapping is enabled, we are relying on setup_IO_APIC_irqs() to configure remapped entries in the IO-APIC, which comes little bit later after enabling interrupt-remapping. Meanwhile, restoration of old io-apic entries after enabling interrupt-remapping will not make the interrupts through io-apic functional anyway. So remove the unnecessary reinit_intr_remapped_IO_APIC() step. The longer story: When interrupt-remapping is enabled, IO-APIC entries need to be setup in the re-mappable format (pointing to interrupt-remapping table entries setup by the OS). This remapping configuration is happening in the same place where we traditionally configure IO-APIC (i.e., in setup_IO_APIC_irqs()). So when we enable interrupt-remapping successfully, there is no need to restore old io-apic RTE entries before we actually do a complete configuration shortly in setup_IO_APIC_irqs(). Old IO-APIC RTE's may be in traditional format (non re-mappable) or in re-mappable format pointing to interrupt-remapping table entries setup by BIOS. Restoring both of these will not make IO-APIC functional. We have to rely on setup_IO_APIC_irqs() for proper configuration by OS. So I am removing this unnecessary and broken step. [ Impact: remove unnecessary/broken IO-APIC setup step ] Signed-off-by: Suresh Siddha <suresh.b.siddha@intel.com> Acked-by: Weidong Han <weidong.han@intel.com> Cc: dwmw2@infradead.org LKML-Reference: <20090420200450.552359000@linux-os.sc.intel.com> Signed-off-by: Ingo Molnar <mingo@elte.hu> |
||
---|---|---|
.. | ||
alpha | ||
arm | ||
avr32 | ||
blackfin | ||
cris | ||
frv | ||
h8300 | ||
ia64 | ||
m32r | ||
m68k | ||
m68knommu | ||
microblaze | ||
mips | ||
mn10300 | ||
parisc | ||
powerpc | ||
s390 | ||
sh | ||
sparc | ||
um | ||
x86 | ||
xtensa | ||
.gitignore | ||
Kconfig |