linux/drivers/w1/masters/Kconfig
Paul Walmsley d660030061 W1: OMAP HDQ1W: allow driver to be built on all OMAP2+
Allow the OMAP HDQ1W driver to be built for all OMAP2+ SoCs by
adjusting KConfig dependencies.  The previous dependency required
either SOC_OMAP2430 or ARCH_OMAP3 to be set, but the HDQ IP block is
present on OMAP2420 and OMAP44xx SoCs.  The driver was still
selectable on multi-OMAP kernel configurations, however; so the
previous prohibition was rather pointless.

Signed-off-by: Paul Walmsley <paul@pwsan.com>
Cc: Evgeniy Polyakov <zbr@ioremap.net>
Acked-by: Evgeniy Polyakov <zbr@ioremap.net>
2012-06-21 21:40:37 -06:00

70 lines
1.8 KiB
Plaintext

#
# 1-wire bus master configuration
#
menu "1-wire Bus Masters"
config W1_MASTER_MATROX
tristate "Matrox G400 transport layer for 1-wire"
depends on PCI
help
Say Y here if you want to communicate with your 1-wire devices
using Matrox's G400 GPIO pins.
This support is also available as a module. If so, the module
will be called matrox_w1.
config W1_MASTER_DS2490
tristate "DS2490 USB <-> W1 transport layer for 1-wire"
depends on USB
help
Say Y here if you want to have a driver for DS2490 based USB <-> W1 bridges,
for example DS9490*.
This support is also available as a module. If so, the module
will be called ds2490.
config W1_MASTER_DS2482
tristate "Maxim DS2482 I2C to 1-Wire bridge"
depends on I2C && EXPERIMENTAL
help
If you say yes here you get support for the Maxim DS2482
I2C to 1-Wire bridge.
This driver can also be built as a module. If so, the module
will be called ds2482.
config W1_MASTER_MXC
tristate "Freescale MXC 1-wire busmaster"
depends on W1 && ARCH_MXC
help
Say Y here to enable MXC 1-wire host
config W1_MASTER_DS1WM
tristate "Maxim DS1WM 1-wire busmaster"
depends on W1 && GENERIC_HARDIRQS
help
Say Y here to enable the DS1WM 1-wire driver, such as that
in HP iPAQ devices like h5xxx, h2200, and ASIC3-based like
hx4700.
config W1_MASTER_GPIO
tristate "GPIO 1-wire busmaster"
depends on GENERIC_GPIO
help
Say Y here if you want to communicate with your 1-wire devices using
GPIO pins. This driver uses the GPIO API to control the wire.
This support is also available as a module. If so, the module
will be called w1-gpio.
config HDQ_MASTER_OMAP
tristate "OMAP HDQ driver"
depends on ARCH_OMAP2PLUS
help
Say Y here if you want support for the 1-wire or HDQ Interface
on an OMAP processor.
endmenu