Devin Heitmueller cdf7bfa892 V4L/DVB (12100): em28xx: make sure the analog GPIOs are set if we used a card hint ... In cases where the board had a default USB ID, we would not indentify the board until after the call to em28xx_set_mode(). As a result, for those boards the analog GPIOs were not being set before probing the i2c bus for devices (the probe would occur with the GPIOs being all high). Make a call to em28xx_set_mode() so that the GPIOs are set properly before probing the i2c bus for devices. This problem was detected with the EVGA inDtube, where the tvp5150 is not powered on unless GPIO1 is pulled low. Signed-off-by: Devin Heitmueller <dheitmueller@kernellabs.com> Signed-off-by: Mauro Carvalho Chehab <mchehab@redhat.com>		2009-06-23 03:14:16 -03:00
..
common	Merge branch 'for_linus' of git://git.kernel.org/pub/scm/linux/kernel/git/mchehab/linux-2.6	2009-06-16 21:15:42 -07:00
dvb	V4L/DVB (12098): Create table for customize stv0900 ts registers.	2009-06-23 03:14:12 -03:00
radio	V4L/DVB (11957): dsbr100: change radio->muted to radio->status, update suspend/resume	2009-06-16 19:07:36 -03:00
video	V4L/DVB (12100): em28xx: make sure the analog GPIOs are set if we used a card hint	2009-06-23 03:14:16 -03:00
Kconfig	V4L/DVB (11881): one kconfig controls them all	2009-06-16 18:21:16 -03:00
Makefile	V4L/DVB (8274): sms1xxx: build cleanup after driver relocation	2008-07-20 07:20:56 -03:00