linux/drivers/net/can/softing/Kconfig
Marc Kleine-Budde 6586c5d74e can: Kconfig: convert 'depends on CAN_DEV' into 'if CAN_DEV...endif' block
This patch adds an 'if CAN_DEV...endif' Block around the CAN driver
symbols in drivers/net/can/Kconfig. So the 'depends on CAN' dependencies
can be removed.

Signed-off-by: Marc Kleine-Budde <mkl@pengutronix.de>
2013-01-26 16:58:58 +01:00

31 lines
1.2 KiB
Plaintext

config CAN_SOFTING
tristate "Softing Gmbh CAN generic support"
depends on HAS_IOMEM
---help---
Support for CAN cards from Softing Gmbh & some cards
from Vector Gmbh.
Softing Gmbh CAN cards come with 1 or 2 physical busses.
Those cards typically use Dual Port RAM to communicate
with the host CPU. The interface is then identical for PCI
and PCMCIA cards. This driver operates on a platform device,
which has been created by softing_cs or softing_pci driver.
Warning:
The API of the card does not allow fine control per bus, but
controls the 2 busses on the card together.
As such, some actions (start/stop/busoff recovery) on 1 bus
must bring down the other bus too temporarily.
config CAN_SOFTING_CS
tristate "Softing Gmbh CAN pcmcia cards"
depends on PCMCIA
depends on CAN_SOFTING
---help---
Support for PCMCIA cards from Softing Gmbh & some cards
from Vector Gmbh.
You need firmware for these, which you can get at
http://developer.berlios.de/projects/socketcan/
This version of the driver is written against
firmware version 4.6 (softing-fw-4.6-binaries.tar.gz)
In order to use the card as CAN device, you need the Softing generic
support too.