linux/arch/arm/mach-omap2/board-flash.c
Tony Lindgren d1589f0912 ARM: OMAP2+: Mark omap_hsmmc_init and omap_mux related functions as __init
Now that omap hsmmc init is split into two functions, it's safe
to mark omap_hsmmc_init and omap_mux related functions to __init.

This basically reverts the following fixes for the case where
TWL was compiled as a module:

a98f77b (ARM: omap: fix section mismatch warning for sdp3430_twl_gpio_setup())
8930b4e (ARM: omap: fix section mismatch warnings in mux.c caused by hsmmc.c)

Additionally it fixes up the remaining section warnings for
all callers of omap_mux functions.

Cc: Russell King <rmk+kernel@arm.linux.org.uk>
Signed-off-by: Tony Lindgren <tony@atomide.com>
2012-02-24 13:04:10 -08:00

248 lines
6.1 KiB
C

/*
* board-flash.c
* Modified from mach-omap2/board-3430sdp-flash.c
*
* Copyright (C) 2009 Nokia Corporation
* Copyright (C) 2009 Texas Instruments
*
* Vimal Singh <vimalsingh@ti.com>
*
* This program is free software; you can redistribute it and/or modify
* it under the terms of the GNU General Public License version 2 as
* published by the Free Software Foundation.
*/
#include <linux/kernel.h>
#include <linux/platform_device.h>
#include <linux/mtd/physmap.h>
#include <linux/io.h>
#include <plat/irqs.h>
#include <plat/gpmc.h>
#include <plat/nand.h>
#include <plat/onenand.h>
#include <plat/tc.h>
#include "board-flash.h"
#define REG_FPGA_REV 0x10
#define REG_FPGA_DIP_SWITCH_INPUT2 0x60
#define MAX_SUPPORTED_GPMC_CONFIG 3
#define DEBUG_BASE 0x08000000 /* debug board */
/* various memory sizes */
#define FLASH_SIZE_SDPV1 SZ_64M /* NOR flash (64 Meg aligned) */
#define FLASH_SIZE_SDPV2 SZ_128M /* NOR flash (256 Meg aligned) */
static struct physmap_flash_data board_nor_data = {
.width = 2,
};
static struct resource board_nor_resource = {
.flags = IORESOURCE_MEM,
};
static struct platform_device board_nor_device = {
.name = "physmap-flash",
.id = 0,
.dev = {
.platform_data = &board_nor_data,
},
.num_resources = 1,
.resource = &board_nor_resource,
};
static void
__init board_nor_init(struct mtd_partition *nor_parts, u8 nr_parts, u8 cs)
{
int err;
board_nor_data.parts = nor_parts;
board_nor_data.nr_parts = nr_parts;
/* Configure start address and size of NOR device */
if (omap_rev() >= OMAP3430_REV_ES1_0) {
err = gpmc_cs_request(cs, FLASH_SIZE_SDPV2 - 1,
(unsigned long *)&board_nor_resource.start);
board_nor_resource.end = board_nor_resource.start
+ FLASH_SIZE_SDPV2 - 1;
} else {
err = gpmc_cs_request(cs, FLASH_SIZE_SDPV1 - 1,
(unsigned long *)&board_nor_resource.start);
board_nor_resource.end = board_nor_resource.start
+ FLASH_SIZE_SDPV1 - 1;
}
if (err < 0) {
pr_err("NOR: Can't request GPMC CS\n");
return;
}
if (platform_device_register(&board_nor_device) < 0)
pr_err("Unable to register NOR device\n");
}
#if defined(CONFIG_MTD_ONENAND_OMAP2) || \
defined(CONFIG_MTD_ONENAND_OMAP2_MODULE)
static struct omap_onenand_platform_data board_onenand_data = {
.dma_channel = -1, /* disable DMA in OMAP OneNAND driver */
};
static void
__init board_onenand_init(struct mtd_partition *onenand_parts,
u8 nr_parts, u8 cs)
{
board_onenand_data.cs = cs;
board_onenand_data.parts = onenand_parts;
board_onenand_data.nr_parts = nr_parts;
gpmc_onenand_init(&board_onenand_data);
}
#else
static void
__init board_onenand_init(struct mtd_partition *nor_parts, u8 nr_parts, u8 cs)
{
}
#endif /* CONFIG_MTD_ONENAND_OMAP2 || CONFIG_MTD_ONENAND_OMAP2_MODULE */
#if defined(CONFIG_MTD_NAND_OMAP2) || \
defined(CONFIG_MTD_NAND_OMAP2_MODULE)
/* Note that all values in this struct are in nanoseconds */
static struct gpmc_timings nand_timings = {
.sync_clk = 0,
.cs_on = 0,
.cs_rd_off = 36,
.cs_wr_off = 36,
.adv_on = 6,
.adv_rd_off = 24,
.adv_wr_off = 36,
.we_off = 30,
.oe_off = 48,
.access = 54,
.rd_cycle = 72,
.wr_cycle = 72,
.wr_access = 30,
.wr_data_mux_bus = 0,
};
static struct omap_nand_platform_data board_nand_data = {
.gpmc_t = &nand_timings,
};
void
__init board_nand_init(struct mtd_partition *nand_parts,
u8 nr_parts, u8 cs, int nand_type)
{
board_nand_data.cs = cs;
board_nand_data.parts = nand_parts;
board_nand_data.nr_parts = nr_parts;
board_nand_data.devsize = nand_type;
board_nand_data.ecc_opt = OMAP_ECC_HAMMING_CODE_DEFAULT;
board_nand_data.gpmc_irq = OMAP_GPMC_IRQ_BASE + cs;
gpmc_nand_init(&board_nand_data);
}
#endif /* CONFIG_MTD_NAND_OMAP2 || CONFIG_MTD_NAND_OMAP2_MODULE */
/**
* get_gpmc0_type - Reads the FPGA DIP_SWITCH_INPUT_REGISTER2 to get
* the various cs values.
*/
static u8 get_gpmc0_type(void)
{
u8 cs = 0;
void __iomem *fpga_map_addr;
fpga_map_addr = ioremap(DEBUG_BASE, 4096);
if (!fpga_map_addr)
return -ENOMEM;
if (!(__raw_readw(fpga_map_addr + REG_FPGA_REV)))
/* we dont have an DEBUG FPGA??? */
/* Depend on #defines!! default to strata boot return param */
goto unmap;
/* S8-DIP-OFF = 1, S8-DIP-ON = 0 */
cs = __raw_readw(fpga_map_addr + REG_FPGA_DIP_SWITCH_INPUT2) & 0xf;
/* ES2.0 SDP's onwards 4 dip switches are provided for CS */
if (omap_rev() >= OMAP3430_REV_ES1_0)
/* change (S8-1:4=DS-2:0) to (S8-4:1=DS-2:0) */
cs = ((cs & 8) >> 3) | ((cs & 4) >> 1) |
((cs & 2) << 1) | ((cs & 1) << 3);
else
/* change (S8-1:3=DS-2:0) to (S8-3:1=DS-2:0) */
cs = ((cs & 4) >> 2) | (cs & 2) | ((cs & 1) << 2);
unmap:
iounmap(fpga_map_addr);
return cs;
}
/**
* board_flash_init - Identify devices connected to GPMC and register.
*
* @return - void.
*/
void __init board_flash_init(struct flash_partitions partition_info[],
char chip_sel_board[][GPMC_CS_NUM], int nand_type)
{
u8 cs = 0;
u8 norcs = GPMC_CS_NUM + 1;
u8 nandcs = GPMC_CS_NUM + 1;
u8 onenandcs = GPMC_CS_NUM + 1;
u8 idx;
unsigned char *config_sel = NULL;
/* REVISIT: Is this return correct idx for 2430 SDP?
* for which cs configuration matches for 2430 SDP?
*/
idx = get_gpmc0_type();
if (idx >= MAX_SUPPORTED_GPMC_CONFIG) {
pr_err("%s: Invalid chip select: %d\n", __func__, cs);
return;
}
config_sel = (unsigned char *)(chip_sel_board[idx]);
while (cs < GPMC_CS_NUM) {
switch (config_sel[cs]) {
case PDC_NOR:
if (norcs > GPMC_CS_NUM)
norcs = cs;
break;
case PDC_NAND:
if (nandcs > GPMC_CS_NUM)
nandcs = cs;
break;
case PDC_ONENAND:
if (onenandcs > GPMC_CS_NUM)
onenandcs = cs;
break;
};
cs++;
}
if (norcs > GPMC_CS_NUM)
pr_err("NOR: Unable to find configuration in GPMC\n");
else
board_nor_init(partition_info[0].parts,
partition_info[0].nr_parts, norcs);
if (onenandcs > GPMC_CS_NUM)
pr_err("OneNAND: Unable to find configuration in GPMC\n");
else
board_onenand_init(partition_info[1].parts,
partition_info[1].nr_parts, onenandcs);
if (nandcs > GPMC_CS_NUM)
pr_err("NAND: Unable to find configuration in GPMC\n");
else
board_nand_init(partition_info[2].parts,
partition_info[2].nr_parts, nandcs, nand_type);
}