linux/drivers/net/wireless/rtl8187.h
Johannes Berg 4150c57212 [PATCH] mac80211: revamp interface and filter configuration
Drivers are currently supposed to keep track of monitor
interfaces if they allow so-called "hard" monitor, and
they are also supposed to keep track of multicast etc.

This patch changes that, replaces the set_multicast_list()
callback with a new configure_filter() callback that takes
filter flags (FIF_*) instead of interface flags (IFF_*).
For a driver, this means it should open the filter as much
as necessary to get all frames requested by the filter flags.
Accordingly, the filter flags are named "positively", e.g.
FIF_ALLMULTI.

Multicast filtering is a bit special in that drivers that
have no multicast address filters need to allow multicast
frames through when either the FIF_ALLMULTI flag is set or
when the mc_count value is positive.

At the same time, drivers are no longer notified about
monitor interfaces at all, this means they now need to
implement the start() and stop() callbacks and the new
change_filter_flags() callback. Also, the start()/stop()
ordering changed, start() is now called *before* any
add_interface() as it really should be, and stop() after
any remove_interface().

The patch also changes the behaviour of setting the bssid
to multicast for scanning when IEEE80211_HW_NO_PROBE_FILTERING
is set; the IEEE80211_HW_NO_PROBE_FILTERING flag is removed
and the filter flag FIF_BCN_PRBRESP_PROMISC introduced.
This is a lot more efficient for hardware like b43 that
supports it and other hardware can still set the BSSID
to all-ones.

Driver modifications by Johannes Berg (b43 & iwlwifi), Michael Wu
(rtl8187, adm8211, and p54), Larry Finger (b43legacy), and
Ivo van Doorn (rt2x00).

Signed-off-by: Johannes Berg <johannes@sipsolutions.net>
Signed-off-by: Michael Wu <flamingice@sourmilk.net>
Signed-off-by: Larry Finger <Larry.Finger@lwfinger.net>
Signed-off-by: Ivo van Doorn <IvDoorn@gmail.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
2007-10-10 16:52:57 -07:00

146 lines
3.6 KiB
C

/*
* Definitions for RTL8187 hardware
*
* Copyright 2007 Michael Wu <flamingice@sourmilk.net>
* Copyright 2007 Andrea Merello <andreamrl@tiscali.it>
*
* Based on the r8187 driver, which is:
* Copyright 2005 Andrea Merello <andreamrl@tiscali.it>, et al.
*
* This program is free software; you can redistribute it and/or modify
* it under the terms of the GNU General Public License version 2 as
* published by the Free Software Foundation.
*/
#ifndef RTL8187_H
#define RTL8187_H
#include "rtl818x.h"
#define RTL8187_EEPROM_TXPWR_BASE 0x05
#define RTL8187_EEPROM_MAC_ADDR 0x07
#define RTL8187_EEPROM_TXPWR_CHAN_1 0x16 /* 3 channels */
#define RTL8187_EEPROM_TXPWR_CHAN_6 0x1B /* 2 channels */
#define RTL8187_EEPROM_TXPWR_CHAN_4 0x3D /* 2 channels */
#define RTL8187_REQT_READ 0xC0
#define RTL8187_REQT_WRITE 0x40
#define RTL8187_REQ_GET_REG 0x05
#define RTL8187_REQ_SET_REG 0x05
#define RTL8187_MAX_RX 0x9C4
struct rtl8187_rx_info {
struct urb *urb;
struct ieee80211_hw *dev;
};
struct rtl8187_rx_hdr {
__le32 flags;
u8 noise;
u8 signal;
u8 agc;
u8 reserved;
__le64 mac_time;
} __attribute__((packed));
struct rtl8187_tx_info {
struct ieee80211_tx_control *control;
struct urb *urb;
struct ieee80211_hw *dev;
};
struct rtl8187_tx_hdr {
__le32 flags;
#define RTL8187_TX_FLAG_NO_ENCRYPT (1 << 15)
#define RTL8187_TX_FLAG_MORE_FRAG (1 << 17)
#define RTL8187_TX_FLAG_CTS (1 << 18)
#define RTL8187_TX_FLAG_RTS (1 << 23)
__le16 rts_duration;
__le16 len;
__le32 retry;
} __attribute__((packed));
struct rtl8187_priv {
/* common between rtl818x drivers */
struct rtl818x_csr *map;
void (*rf_init)(struct ieee80211_hw *);
int mode;
int if_id;
/* rtl8187 specific */
struct ieee80211_channel channels[14];
struct ieee80211_rate rates[12];
struct ieee80211_hw_mode modes[2];
struct usb_device *udev;
u32 rx_conf;
u16 txpwr_base;
u8 asic_rev;
struct sk_buff_head rx_queue;
};
void rtl8187_write_phy(struct ieee80211_hw *dev, u8 addr, u32 data);
static inline u8 rtl818x_ioread8(struct rtl8187_priv *priv, u8 *addr)
{
u8 val;
usb_control_msg(priv->udev, usb_rcvctrlpipe(priv->udev, 0),
RTL8187_REQ_GET_REG, RTL8187_REQT_READ,
(unsigned long)addr, 0, &val, sizeof(val), HZ / 2);
return val;
}
static inline u16 rtl818x_ioread16(struct rtl8187_priv *priv, __le16 *addr)
{
__le16 val;
usb_control_msg(priv->udev, usb_rcvctrlpipe(priv->udev, 0),
RTL8187_REQ_GET_REG, RTL8187_REQT_READ,
(unsigned long)addr, 0, &val, sizeof(val), HZ / 2);
return le16_to_cpu(val);
}
static inline u32 rtl818x_ioread32(struct rtl8187_priv *priv, __le32 *addr)
{
__le32 val;
usb_control_msg(priv->udev, usb_rcvctrlpipe(priv->udev, 0),
RTL8187_REQ_GET_REG, RTL8187_REQT_READ,
(unsigned long)addr, 0, &val, sizeof(val), HZ / 2);
return le32_to_cpu(val);
}
static inline void rtl818x_iowrite8(struct rtl8187_priv *priv,
u8 *addr, u8 val)
{
usb_control_msg(priv->udev, usb_sndctrlpipe(priv->udev, 0),
RTL8187_REQ_SET_REG, RTL8187_REQT_WRITE,
(unsigned long)addr, 0, &val, sizeof(val), HZ / 2);
}
static inline void rtl818x_iowrite16(struct rtl8187_priv *priv,
__le16 *addr, u16 val)
{
__le16 buf = cpu_to_le16(val);
usb_control_msg(priv->udev, usb_sndctrlpipe(priv->udev, 0),
RTL8187_REQ_SET_REG, RTL8187_REQT_WRITE,
(unsigned long)addr, 0, &buf, sizeof(buf), HZ / 2);
}
static inline void rtl818x_iowrite32(struct rtl8187_priv *priv,
__le32 *addr, u32 val)
{
__le32 buf = cpu_to_le32(val);
usb_control_msg(priv->udev, usb_sndctrlpipe(priv->udev, 0),
RTL8187_REQ_SET_REG, RTL8187_REQT_WRITE,
(unsigned long)addr, 0, &buf, sizeof(buf), HZ / 2);
}
#endif /* RTL8187_H */