linux/net/ncsi/Kconfig
Ivan Mikhaylov abd2fddc94 net/ncsi: add NCSI Intel OEM command to keep PHY up
This allows to keep PHY link up and prevents any channel resets during
the host load.

It is KEEP_PHY_LINK_UP option(Veto bit) in i210 datasheet which
block PHY reset and power state changes.

Signed-off-by: Ivan Mikhaylov <i.mikhaylov@yadro.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
2021-07-08 14:16:39 -07:00

26 lines
725 B
Plaintext

# SPDX-License-Identifier: GPL-2.0-only
#
# Configuration for NCSI support
#
config NET_NCSI
bool "NCSI interface support"
depends on INET
help
This module provides NCSI (Network Controller Sideband Interface)
support. Enable this only if your system connects to a network
device via NCSI and the ethernet driver you're using supports
the protocol explicitly.
config NCSI_OEM_CMD_GET_MAC
bool "Get NCSI OEM MAC Address"
depends on NET_NCSI
help
This allows to get MAC address from NCSI firmware and set them back to
controller.
config NCSI_OEM_CMD_KEEP_PHY
bool "Keep PHY Link up"
depends on NET_NCSI
help
This allows to keep PHY link up and prevents any channel resets during
the host load.