During an audio playback session it is observed that, audio goes off after
few seconds of continuous pause and play. No audio is heard even when the
playback is resumed.
The reason for above is, currently ADMA driver does not handle DMA_PAUSE/
DMA_RESUME and relevant callbacks for dma_device are not implemented. This
patch implements device_pause and device_resume callbacks for the device.
During pause TRANSFER_PAUSE bit of dma channel control register is set and
the same is cleared during resume.
Signed-off-by: Sameer Pujar <spujar@nvidia.com>
Reviewed-by: Jon Hunter <jonathanh@nvidia.com>
Signed-off-by: Vinod Koul <vkoul@kernel.org>
Add Tegra186 specific macro defines and chip_data structure for chip
specific information. New compatibility is added to select relevant
chip details. There is no major change for Tegra194 and hence it can
use the same chip data.
The bits in the BURST_SIZE field of the ADMA CH_CONFIG register are
encoded differently on Tegra186 and Tegra194 compared with Tegra210.
On Tegra210 the bits are encoded as follows ...
1 = WORD_1
2 = WORDS_2
3 = WORDS_4
4 = WORDS_8
5 = WORDS_16
Where as on Tegra186 and Tegra194 the bits are encoded as ...
0 = WORD_1
1 = WORDS_2
2 = WORDS_3
3 = WORDS_4
4 = WORDS_5
...
15 = WORDS_16
Add helper functions for generating the correct burst size.
Signed-off-by: Sameer Pujar <spujar@nvidia.com>
Reviewed-by: Jon Hunter <jonathanh@nvidia.com>
Signed-off-by: Vinod Koul <vkoul@kernel.org>
This is a preparatory patch to add support for Tegra186 and Tegra194 chips.
Following changes are necessary to make driver code generic.
* chip_data structure is enhanced to have chip specific details and
following are the additions to the structure
* Offset addresses for ADMA global and channel registers
* Offset values for Tx and Rx channel selection
* Maximum supported Tx and Rx channels
* Tx and Rx channel request mask
* ADMA channel register space size
* Make use of above chip_data to generalise the driver code
Support for Tegra186 and Tegra194 will be added in subsequent patches of
the series.
Signed-off-by: Sameer Pujar <spujar@nvidia.com>
Reviewed-by: Jon Hunter <jonathanh@nvidia.com>
Signed-off-by: Vinod Koul <vkoul@kernel.org>
If the driver is active till late suspend, where runtime PM cannot run,
force suspend is essential in such case to put the device in low power
state. Thus pm_runtime_force_suspend and pm_runtime_force_resume are
used as system sleep callbacks during system wide PM transitions.
Late system sleep callbacks are used to ensure, for instance, that the
sound core has suspended any on-going activity, including stopping the
ADMA if active, before we attempt to suspend the ADMA.
Suggested-by: Jonathan Hunter <jonathanh@nvidia.com>
Signed-off-by: Sameer Pujar <spujar@nvidia.com>
Acked-by: Jon Hunter <jonathanh@nvidia.com>
Signed-off-by: Vinod Koul <vkoul@kernel.org>
adma driver is using pm_clk_*() interface for managing clock resources.
With this it is observed that clocks remain ON always. This happens on
Tegra devices which use BPMP co-processor to manage clock resources,
where clocks are enabled during prepare phase. This is necessary because
clocks to BPMP are always blocking. When pm_clk_*() interface is used on
such Tegra devices, clock prepare count is not balanced till remove call
happens for the driver and hence clocks are seen ON always. Thus this
patch replaces pm_clk_*() with devm_clk_*() framework.
Suggested-by: Mohan Kumar D <mkumard@nvidia.com>
Reviewed-by: Jonathan Hunter <jonathanh@nvidia.com>
Signed-off-by: Sameer Pujar <spujar@nvidia.com>
Signed-off-by: Vinod Koul <vkoul@kernel.org>
One of the more common cases of allocation size calculations is finding
the size of a structure that has a zero-sized array at the end, along
with memory for some number of elements for that array. For example:
struct foo {
int stuff;
void *entry[];
};
instance = devm_kzalloc(dev, sizeof(struct foo) + sizeof(void *) * count, GFP_KERNEL);
Instead of leaving these open-coded and prone to type mistakes, we can
now use the new struct_size() helper:
instance = devm_kzalloc(dev, struct_size(instance, entry, count), GFP_KERNEL);
This code was detected with the help of Coccinelle.
Signed-off-by: Gustavo A. R. Silva <gustavo@embeddedor.com>
Signed-off-by: Vinod Koul <vkoul@kernel.org>
of_irq_get() may return 0 as well as negative error number on failure,
while the driver only checks for the negative values. The driver would then
call request_irq(0, ...) in tegra_adma_alloc_chan_resources() and never get
valid channel interrupt.
Check for 'tdc->irq <= 0' instead and return -ENXIO from the driver's probe
iff of_irq_get() returned 0.
Fixes: f46b195799 ("dmaengine: tegra-adma: Add support for Tegra210 ADMA")
Signed-off-by: Sergei Shtylyov <sergei.shtylyov@cogentembedded.com>
Acked-by: Thierry Reding <treding@nvidia.com>
Acked-by: Jon Hunter <jonathanh@nvidia.com>
Signed-off-by: Vinod Koul <vinod.koul@intel.com>
Commit 498b5fdd40 ("PM / clk: Add support for adding a specific clock
from device-tree") add a new helper function for adding a clock from
device-tree to a device. Update the ADMA driver to use this new function
to simplify the driver.
Signed-off-by: Jon Hunter <jonathanh@nvidia.com>
Acked-by: Laxman Dewangan <ldewangan@nvidia.com>
Signed-off-by: Vinod Koul <vinod.koul@intel.com>
Add support for the Tegra210 Audio DMA controller that is used for
transferring data between system memory and the Audio sub-system.
The driver only supports cyclic transfers because this is being solely
used for audio.
This driver is based upon the work by Dara Ramesh <dramesh@nvidia.com>.
Signed-off-by: Jon Hunter <jonathanh@nvidia.com>
Signed-off-by: Vinod Koul <vinod.koul@intel.com>
