Commit graph

24 commits

Author SHA1 Message Date
Matthew Wilcox 3c0cf138d7 NVMe: Allow fatal signals to interrupt I/O
If the user sends a fatal signal, sleeping in the TASK_KILLABLE state
permits the task to be aborted.  The only wrinkle is making sure that
if/when the command completes later that it doesn't upset anything.
Handle this by setting the data pointer to 0, and checking the value
isn't NULL in the sync completion path.  Eventually, bios can be cancelled
through this path too.  Note that the cmdid isn't freed to prevent reuse.

We should also abort the command in the future, but this is a good start.

Signed-off-by: Matthew Wilcox <matthew.r.wilcox@intel.com>
2011-11-04 15:52:55 -04:00
Matthew Wilcox db5d0c198d NVMe: Release 0.2
Signed-off-by: Matthew Wilcox <matthew.r.wilcox@intel.com>
2011-11-04 15:52:54 -04:00
Matthew Wilcox 6ee44cdced NVMe: Add download / activate firmware ioctls
Signed-off-by: Matthew Wilcox <matthew.r.wilcox@intel.com>
2011-11-04 15:52:54 -04:00
Matthew Wilcox 388f037f4e NVMe: Move sysfs entries to the right place
Because I wasn't setting driverfs_dev, the devices were showing up under
/sys/devices/virtual/block.  Now they appear underneath the PCI device
which they belong to.

Signed-off-by: Matthew Wilcox <matthew.r.wilcox@intel.com>
2011-11-04 15:52:54 -04:00
Shane Michael Matthews 5911f20039 NVMe: Disable the device before we write the admin queues
In case the card has been left in a partially-configured state,
write 0 to the Enable bit.

Signed-off-by: Shane Michael Matthews <shane.matthews@intel.com>
Signed-off-by: Matthew Wilcox <matthew.r.wilcox@intel.com>
2011-11-04 15:52:54 -04:00
Matthew Wilcox 574e8b95bc NVMe: Request I/O regions
Calling pci_request_selected_regions() reserves these regions for our use.

Signed-off-by: Matthew Wilcox <matthew.r.wilcox@intel.com>
2011-11-04 15:52:54 -04:00
Matthew Wilcox 2930353f9f NVMe: Allow queues to be allocated above 4GB
Need to call dma_set_coherent_mask() to allow queues to be allocated
above 4GB.

Signed-off-by: Matthew Wilcox <matthew.r.wilcox@intel.com>
2011-11-04 15:52:53 -04:00
Matthew Wilcox f64d3365a3 NVMe: Enable device DMA
Need to call pci_set_master() to enable device DMA

Signed-off-by: Matthew Wilcox <matthew.r.wilcox@intel.com>
2011-11-04 15:52:53 -04:00
Shane Michael Matthews 0ee5a7d7cb NVMe: Enable and disable the PCI device
Call pci_enable_device_mem() at initialisation and pci_disable_device
at exit.

Signed-off-by: Shane Michael Matthews <shane.matthews@intel.com>
Signed-off-by: Matthew Wilcox <matthew.r.wilcox@intel.com>
2011-11-04 15:52:53 -04:00
Matthew Wilcox 3f85d50b60 NVMe: Check returns from nvme_alloc_queue()
It can return NULL, so handle that.

Signed-off-by: Matthew Wilcox <matthew.r.wilcox@intel.com>
2011-11-04 15:52:53 -04:00
Matthew Wilcox 8e9f0e7115 NVMe: Remove 'node' from nvme_dev
We don't keep a list of nvme_dev any more

Signed-off-by: Matthew Wilcox <matthew.r.wilcox@intel.com>
2011-11-04 15:52:53 -04:00
Matthew Wilcox 51814232ec NVMe: Read the model, serial & firmware rev from the controller
Signed-off-by: Matthew Wilcox <matthew.r.wilcox@intel.com>
2011-11-04 15:52:53 -04:00
Matthew Wilcox a53295b699 NVMe: Add NVME_IOCTL_SUBMIT_IO
Allow userspace to submit synchronous I/O like the SCSI sg interface does.

Signed-off-by: Matthew Wilcox <matthew.r.wilcox@intel.com>
2011-11-04 15:52:53 -04:00
Matthew Wilcox 7fc3cdabba NVMe: Create nvme_map_user_pages() and nvme_unmap_user_pages()
These are generalisations of the code that was in
nvme_submit_user_admin_command().

Signed-off-by: Matthew Wilcox <matthew.r.wilcox@intel.com>
2011-11-04 15:52:52 -04:00
Matthew Wilcox bd38c5557c NVMe: Change NVME_IOCTL_GET_RANGE_TYPE to return all the ranges
Factor out most of nvme_identify() into a new nvme_submit_user_admin_command()
function.  Change nvme_get_range_type() to call it and change nvme_ioctl to
realise that it's getting back all 64 ranges.

Signed-off-by: Matthew Wilcox <matthew.r.wilcox@intel.com>
2011-11-04 15:52:52 -04:00
Matthew Wilcox b8deb62cf2 NVMe: Zero the command before we send it
Make sure there's no left-over bits set from previous commands that used
this slot.

Signed-off-by: Matthew Wilcox <matthew.r.wilcox@intel.com>
2011-11-04 15:52:52 -04:00
Matthew Wilcox ff22b54fda NVMe: Add nvme_setup_prps()
Generalise the code from nvme_identify() that sets PRP1 & PRP2 so that
it's usable for commands sent by nvme_submit_bio_queue().

Signed-off-by: Matthew Wilcox <matthew.r.wilcox@intel.com>
2011-11-04 15:52:52 -04:00
Matthew Wilcox 36c14ed9ca NVMe: Use PRP2 for the nvme_identify ioctl
DMA the result straight to userspace instead of bounce-buffering in the
kernel.

Signed-off-by: Matthew Wilcox <matthew.r.wilcox@intel.com>
2011-11-04 15:52:52 -04:00
Matthew Wilcox 53c9577e9c NVMe: Fix admin IRQ claim on real hardware
The admin IRQ is supposed to use the pin-based (or single message MSI)
interrupt.  Accomplish this by filling in entry[0]'s vector with the
INTx irq number.

Signed-off-by: Matthew Wilcox <matthew.r.wilcox@intel.com>
2011-11-04 15:52:51 -04:00
Matthew Wilcox 821234603b NVMe: Rename 'cycle' to 'phase'
It's called the phase bit in the current draft

Signed-off-by: Matthew Wilcox <matthew.r.wilcox@intel.com>
2011-11-04 15:52:51 -04:00
Matthew Wilcox 1b23484bd0 NVMe: Implement per-CPU queues
Signed-off-by: Matthew Wilcox <matthew.r.wilcox@intel.com>
2011-11-04 15:52:51 -04:00
Matthew Wilcox b3b06812e1 NVMe: Reduce set_queue_count arguments by one
sq_count and cq_count are always the same, so just call it 'count'.

Signed-off-by: Matthew Wilcox <matthew.r.wilcox@intel.com>
2011-11-04 15:52:51 -04:00
Matthew Wilcox 3001082cac NVMe: Factor out queue_request_irq()
Two callers with an almost identical long string of arguments, and
introducing a third soon.  Time to factor out the commonalities.

Signed-off-by: Matthew Wilcox <matthew.r.wilcox@intel.com>
2011-11-04 15:52:51 -04:00
Matthew Wilcox b60503ba43 NVMe: New driver
This driver is for devices that follow the NVM Express standard

Signed-off-by: Matthew Wilcox <matthew.r.wilcox@intel.com>
2011-11-04 15:52:51 -04:00