freebsd-src/sys/dev/sf
Bill Paul d25bb2d026 Modify the Adaptec "starfire" driver to reset the PHY on the MII bus
before selecting a mode. The Seeq PHY chips on the Adaptec cards that
use the AIC-6915 controller seem to need it in order to get them to
change modes correctly.

This corrects a problem that I noticed where my ANA-62022 board failed
to correctly program the full duplex bit in the macconfig1 register
when the interface was brought up. Running ifconfig sf0 would mask this
problem in some cases because polling the PHY status would cause the
miibus code to notice that full duplex was now needed and the statchg
callback would be invoked to configure the duplex setting. However it
would still get it wrong other times.

Also changed sf_miibus_statchg() to program the IPG register to match
the duplex setting in accordance with Adaptec manual's recommendations
(0x15 for full duplex, 0x11 for half duplex).
1999-12-05 20:02:45 +00:00
..
if_sf.c Modify the Adaptec "starfire" driver to reset the PHY on the MII bus 1999-12-05 20:02:45 +00:00
if_sfreg.h Modify the Adaptec "starfire" driver to reset the PHY on the MII bus 1999-12-05 20:02:45 +00:00