was found or not. Fix it's usage. Alas, it caused no problem before,
besides leaving garbage in the stack, because refill, used by [if]
[else] [then], was broken.
a parameter and dtrt.
Also, make boot-conf always unload first. There wasn't really any
point in not doing this, as the kernel _has_ to be loaded before
any other modules.
Tested by: dwhite
with the new binutils. Now that we have a decent assembler, all the old
m4 macros are no longer needed. Instead, straight assembly can be used
since as(1) now understands 16-bit addressing, branches, etc. Also,
several bugs have been fixed in as(1), allowing boot0.s to be further
cleaned up.
be booted. Due to a bug, this wasn't happening.
There is still a lesser bug in that the loader decides which file to boot
after the 10sec count down. This means the bootfile listed in the count
down in is wrong in the case where the loader will boot /kernel.old.
FICL. bootforth is now live on the Alpha!
**BEWARE** - you *MUST* build and install a current libstand or you will
most likely get zfree() panics at loader startup.
We should now be able to set up the loader.conf stuff on the Alpha too.
/boot/loader (even though it is 100% dormant in the Alpha version),
then the loader panics with a zfree error:Loading /boot/loader.test
*** keyboard not plugged in...
Console: SRM firmware console
panic: zfree(0x2003cb58,4096): wild pointer
versus the exact same code but without FICL linked in:
Loading /boot/loader
Console: SRM firmware console
VMS PAL rev: 0x1000600010114
OSF PAL rev: 0x1000600020116
Switch to OSF PAL code succeeded.
FreeBSD/alpha SRM disk boot, Revision 0.1
This is almost certainly an alpha infrastructure bug, not a FICL
problem. It's probably the same thing that made FICL fail for no
apparent reason on the Alpha.
code instead of using 32-bit code and having to just "know" that it's
really 16-bit instructions when things run. This also allows the code
to use fewer macros and more actual assembly statements, which eases
maintenance. Unfortunately, due to as(1) brokenness, we still use m4
macros for all 16-bit addresses, and all short jumps (i.e., 8-bit
relative addresses in the jump instruction) must be wrapped in .code32
directives to avoid useless bloat by as(1). This also fixes a few
problems that were preventing boot0 from compiling with the latest
and greatest version of as(1).
