number of banks, rows and columns the SDRAMC is programmed to access
to determine the RAM size for the board, rather than hard-wiring it to
be 32MB. My company's board with 64MB now probes correctly, as does
the KB9202 with only 32MB. This means that to detect the right memory
size, our boot loader must correctly initialize these values. This is
a fairly safe assumption because the boot loader has to initialize
SDRAM already, and it isn't really possible to change this register
after we've accessed SDRAM.
The boot loader is supposed to leave this bit set to the right value
for the board. If this bit was set at attach time, use it to init the
config register correctly.
Note: this means the boot loader has to properly initialize it.
an explicit comment that it's needed for the linuxolator. This is not the
case anymore. For all other architectures there was only a "KEEP THIS".
I'm (and other people too) running a COMPAT_43-less kernel since it's not
necessary anymore for the linuxolator. Roman is running such a kernel for a
for longer time. No problems so far. And I doubt other (newer than ia32
or alpha) architectures really depend on it.
This may result in a small performance increase for some workloads.
If the removal of COMPAT_43 results in a not working program, please
recompile it and all dependencies and try again before reporting a
problem.
The only place where COMPAT_43 is needed (as in: does not compile without
it) is in the (outdated/not usable since too old) svr4 code.
Note: this does not remove the COMPAT_43TTY option.
Nagging by: rdivacky
There is a race with the current locking scheme and removing
it should have no measurable performance impact.
This fixes page faults leading to panics in pmap_enter_quick_locked()
on amd64/i386.
Reviewed by: alc,jhb,peter,ps
- Try hard to calculate a safe sp, so that the stack doesn't get smashed
while uncompressing or relocating the kernel.
- Bring in code needed to calculate the cacheline size etc, needed for
arm9_idcache_wbinv_all.
current interface with the machine-independent layer. Without this change,
the page daemon would only have been awakened the first time that the
number of pv entries went above the high water mark, not each time.
the first and last cache line in PREREAD, and just invalidate the cache
lines in POSTREAD, instead of write-back/invalidating in POSTREAD, which
could lead to stale data overriding what has been transfered by DMA.
enabled. It has been commented out for a reason I forgot but I suspect
does not apply anymore.
Technically speaking it's not required to do it, has the data and the
instruction cache have been disabled in _start(). However, it may change
in the future, so I don't want to rely on this behavior.
Submitted by: kevlo
