The cloudabi32.ko kernel modules can only be loaded on AMD64 and ARM64
by kernels built with COMPAT_FREEBSD32. Even though COMPAT_FREEBSD32
does not support the execution of native FreeBSD executables, do add it
to GENERIC, to make cloudabi32.ko usable.
According to size(1), this makes the kernel image approximately 0.7%
larger.
Reviewed by: andrew, imp, emaste
Differential Revision: https://reviews.freebsd.org/D13311
Currently, bwn(4) relies on the siba_bwn(4) bus driver to provide support
for the on-chip SSB interconnect found in Broadcom's older PCI(e) Wi-Fi
adapters. Non-PCI Wi-Fi adapters, as well as the newer BCMA interconnect
found in post-2009 Broadcom Wi-Fi hardware, are not supported by
siba_bwn(4).
The bhnd(4) bus driver (also used by the FreeBSD/MIPS Broadcom port)
provides a unified kernel interface to a superset of the hardware supported
by siba_bwn; by attaching bwn(4) via bhnd(4), we can support both modern
PCI(e) Wi-Fi devices based on the BCMA backplane interconnect, as well as
Broadcom MIPS WiSoCs that include a D11 MAC core directly attached to their
SSB or BCMA backplane.
This diff introduces opt-in bwn(4) support for bhnd(4) by providing:
- A small bwn(4) driver subclass, if_bwn_bhnd, that attaches via
bhnd(4) instead of siba_bwn(4).
- A bhndb(4)-based PCI host bridge driver, if_bwn_pci, that optionally
probes at a higher priority than the siba_bwn(4) PCI driver.
- A set of compatibility shims that perform translation of bwn(4)'s
siba_bwn function calls into their bhnd(9) API equivalents when bwn(4)
is attached via a bhnd(4) bus parent. When bwn(4) is attached via
siba_bwn(4), all siba_bwn function calls are simply passed through to
their original implementations.
To test bwn(4) with bhnd(4), place the following lines in loader.conf(5):
hw.bwn_pci.preferred="1"
if_bwn_pci_load="YES
bwn_v4_ucode_load="YES"
bwn_v4_lp_ucode_load="YES"
To verify that bwn(4) is using bhnd(4), you can check dmesg:
bwn0: <Broadcom 802.11 MAC/PHY/Radio, rev 15> ... on bhnd0
... or devinfo(8):
pcib2
pci2
bwn_pci0
bhndb0
bhnd0
bwn0
...
bwn(4)/bhnd(4) has been tested for regressions with most chipsets currently
supported by bwn(4), including:
- BCM4312
- BCM4318
- BCM4321
With minimal changes to the DMA code (not included in this commit), I was
also able to test support for newer BCMA devices by bringing up basic
working Wi-Fi on two previously unsupported, BCMA-based N-PHY chipsets:
- BCM43224
- BCM43225
Approved by: adrian (mentor, implicit)
Sponsored by: The FreeBSD Foundation & Plausible Labs
Differential Revision: https://reviews.freebsd.org/D13041
The Display Interface Unit (DIU) uses main memory for the framebuffer, which
is already mapped as cache coherent physical memory. Prevent mmap() from
using its own attributes which may otherwise conflict.
- Add missing call to device_delete_children() in bhndb_detach(), without
which we're left with stale child devices on module unload.
- Pass the parent PCI device to pci_release_msi(), not the bhndb_pci(4)
child.
Approved by: adrian (mentor, implicit)
Sponsored by: The FreeBSD Foundation
bhnd_chipc's children may hold strong provider references to their parent;
we must detach any children before attempting to deregister the bhnd_chipc
device as a bus service provider.
Approved by: adrian (mentor, implicit)
Sponsored by: The FreeBSD Foundation
Default WARNS to 0 still, since there's still some warnings on other
architectures.
Sponsored by: Netflix
Differential Revision: https://reviews.freebsd.org/D13301
a10_gpio previously accepted only {allwinner,}drive and {allwinner,}pull for
drive/bias setting, while newer DTS is using drive-strength and
bias-{disable,pull-up,pull-down} properties. Accept these properties as
well.
Additionally make bias and drive strength optional rather than required; not
setting them should just indicate that we do not need to configure these
properties.
Tested on: BananaPi-M3 (a83t)
Reviewed by: manu
Approved by: emaste (implicit)
Obtained from: NetBSD (partially)
Differential Revision: https://reviews.freebsd.org/D13284
SIOCGIFXMEDIA is required for extended ethernet media types,
but iflib did not support it.
Reported by: Bhargava Chenna Marreddy <bhargava.marreddy@broadcom.com>
Sponsored by: Limelight Networks
Differential Revision: https://reviews.freebsd.org/D13312
A correct destruction is important for WITNESS(4) and LOCK_PROFILING(9).
Submitted by: Sebastian Huber <sebastian.huber@embedded-brains.de>
MFC after: 1 week
SPDB was cleaned using TAILQ_CONCAT() instead of calling key_unlink()
for each SP, thus we need to properly clean lists in each bucket of
V_sphashtbl to avoid panic in hashdestroy() when INVARIANTS is enabled.
Do the same for V_acqaddrhashtbl and V_acqseqhashtbl.
When we are called in DEFAULT_VNET, destroy also all global locks and
drain key_timer callout.
Reported by: kp
Tested by: kp
MFC after: 1 week
We periodically record synchronization progress in the metadata
block of the disk being synchronized; this allows an interrupted
synchronization to be resumed. However, the frequency of these
updates heavily pessimized synchronization time on some media. This
change modifies gmirror to update metadata based on a time period,
and adds a sysctl to control that period. The default value results
in a much lower update frequency and increases the completion time
for an interrupted rebuild only marginally.
Reported by: Andre Albsmeier <andre@fbsd.e4m.org>
MFC after: 3 weeks
This change adds an implementation of a sysent for running CloudABI
armv6 and armv7 binaries on FreeBSD/arm64. It is a somewhat literal copy
of the armv6 version, except that it's been patched up to use the proper
registers.
Just like for cloudabi32.ko on FreeBSD/amd64, we make use of a vDSO that
automatically pads system call parameters to 64-bit value. These are
stored in a buffer on the stack, meaning we need to use copyin() and
copyout() unconditionally.
"panic: vdev_geom_close_locked: cp->private is NULL"
This panic will result if ZFS fails to open a device due to either of the
following reasons:
1) The device's sector size is greater than 8KB.
2) ZFS wants to open the device RW, but it can't be opened for writing.
The solution is to change the initialization order to ensure that the
assertion will be satisfied.
PR: 221066
Reported by: David NewHamlet <wheelcomplex@gmail.com>
Reviewed by: avg
MFC after: 3 weeks
Sponsored by: Spectra Logic Corp
Differential Revision: https://reviews.freebsd.org/D13278
"panic: vdev_geom_close_locked: cp->private is NULL"
This panic will result if ZFS fails to open a device due to either of the
following reasons:
1) The device's sector size is greater than 8KB.
2) ZFS wants to open the device RW, but it can't be opened for writing.
The solution is to change the initialization order to ensure that the
assertion will be satisfied.
PR: 221066
Reported by: David NewHamlet <wheelcomplex@gmail.com>
Reviewed by: avg
MFC after: 3 weeks
Sponsored by: Spectra Logic Corp
Differential Revision: https://reviews.freebsd.org/D13278
used inside "if" statements comparing with another value.
Detailed explanation:
"if (a ? b : c != 0)" is not the same like "if ((a ? b : c) != 0)"
which is the expected behaviour of a function macro.
Affects:
toecore, linuxkpi and ibcore.
Reviewed by: kib
MFC after: 3 days
Sponsored by: Mellanox Technologies
turn it off by default. It is very inefficient to verify current P-state of
each core, especially for CPUs with many cores. When multiple commands are
requested to the same power domain before completion of pending transitions,
the last command is executed according to the manual. Because requests are
serialized by the caller, all cores will receive the same command for each
call. Do not call sched_bind() and sched_unbind(). It is redundant because
the caller does it anyway.
started, but also by the turnstiles to mark a thread as runnable for
all locks, for instance sleepqueues do:
setrunnable()->sched_wakeup()->sched_add()
In r326218 code was added to allow booting from non-zero CPU numbers
by setting the ts_cpu field inside the ULE scheduler's sched_add()
function. This had an undesired side-effect that prior sched_pin() and
sched_bind() calls got disregarded. This patch fixes the
initialization of the ts_cpu field for the ULE scheduler to only
happen once when the initial thread is constructed during system
init. Forking will then later on ensure that a valid ts_cpu value gets
copied to all children.
Reviewed by: jhb, kib
Discussed with: nwhitehorn
MFC after: 1 month
Differential revision: https://reviews.freebsd.org/D13298
Sponsored by: Mellanox Technologies
It's theoretically possible for the vnode and object to be disassociated
while locks are dropped around the vget() call, in which case we
shouldn't proceed with laundering.
Noted and reviewed by: kib
MFC after: 1 week
If a device didn't support MSI-X, ctx->ifc_cpus would not be initialized,
but the IRQ allocation routines still uses the value. Move the
initialization to common code.
Sponsored by: Limelight Networks
Driver support is only provided for ConnectX4/5.
System-time timestamp is calculated based on the free-running counter
timestamp provided by hardware. Driver periodically samples the
counter to calibrate it against the system clock and uses linear
interpolation to convert. Stability of the crystal which drives the
clock is +-50 ppm at the operational temperature, which makes the
algorithm good enough.
The calculation is somewhat delicate because all values are 64bit and
overflow the naive formula for linear interpolation. The calculation
drops the least significant bits in advance, see the PREC shift in
mlx5_mbuf_tstmp().
Hardware stamps can be turned off by 'ifconfig mceN -hwrxtsmp'. Buggy
firmware might result in small but visible errors in the reported
timestamps, detectable e.g. by nonsensical (negative) RTT values for
LAN pings.
Reviewed by: gallatin, hselasky
Sponsored by: Mellanox Technologies
Differential revision: https://reviews.freebsd.org/D12638
type to any value. This can cause page faults and panics due to accessing
uninitialized fields in the "struct ifnet" which are specific to the network
device type.
MFC after: 1 week
Found by: jau@iki.fi
PR: 223767
Sponsored by: Mellanox Technologies
Devices aren't mapped within the KVA, and with the way 64-bit hashes the
addresses pte_vatopa() may not return a 0 physical address for a device.
MFC after: 1 week
The arena argument to kmem_*() is now only used in an assert. A follow-up
commit will remove the argument altogether before we freeze the API for the
next release.
This replaces the hard limit on kmem size with a soft limit imposed by UMA. When
the soft limit is exceeded we periodically wakeup the UMA reclaim thread to
attempt to shrink KVA. On 32bit architectures this should behave much more
gracefully as we exhaust KVA. On 64bit the limits are likely never hit.
Reviewed by: markj, kib (some objections)
Discussed with: alc
Tested by: pho
Sponsored by: Netflix / Dell EMC Isilon
Differential Revision: https://reviews.freebsd.org/D13187
