By definition, the very first FIN is not a duplicate. Process it normally
and don't feed it to congestion control as though it were a dupe. Don't
prevent CC from seeing later dupe acks while in a half close state.
the INP_INFO lock from tcp_usr_accept. As the PR/patch states
this was following the advice already in the code.
See the PR below for a full disucssion of this change and its
measured effects.
PR: 183659
Submitted by: Julian Charbon
Reviewed by: jhb
pim_input() properly.
While here, remove extra variable and incorrect condition
before m_pullup().
Reported by: Olivier Cochard-Labbé <olivier cochard.me>
Sponsored by: Nginx, Inc.
* Set ia address/mask values BEFORE attaching to address lists.
Inet6 address assignment is not atomic, so the simplest way to
do this atomically is to fill in ia before attach.
* Validate irfa->ia_addr field before use (we permit ANY sockaddr in old code).
* Do some renamings:
in6_ifinit -> in6_notify_ifa (interaction with other subsystems is here)
in6_setup_ifa -> in6_broadcast_ifa (LLE/Multicast/DaD code)
in6_ifaddloop -> nd6_add_ifa_lle
in6_ifremloop -> nd6_rem_ifa_lle
* Split working with LLE and route announce code for last two.
Add temporary in6_newaddrmsg() function to mimic current rtsock behaviour.
* Call device SIOCSIFADDR handler IFF we're adding first address.
In IPv4 we have to call it on every address change since ARP record
is installed by arp_ifinit() which is called by given handler.
IPv6 stack, on the opposite is responsible to call nd6_add_ifa_lle() so
there is no reason to call SIOCSIFADDR often.
of a syncache connection, copy it into the inp_flowid field.
Without this, an incoming TCP connection won't have an inp_flowid marked
until some data comes in, and this means that things like the per-CPU
TCP timer option will choose a different CPU for the timer work.
(It also means that if one grabbed the flowid via an ioctl from userland,
it won't be available until some data has been received.)
Sponsored by: Netflix, Inc.
Problem case:
Original lookup returns route with GW set, so gw points to
rte->rt_gateway.
After that we're changing dst and performing lookup another time.
Since fwd host is most probably directly reachable, resulting
rte does not contain rt_gateway, so gw is not set. Finally, we
end with packet transmitted to proper interface but wrong
link-layer address.
Found by: lstewart
Discussed with: ae,lstewart
MFC after: 2 weeks
Sponsored by: Yandex LLC
has the same prefix as some other alias on the same interface, use
newly-added rt_addrmsg() instead of hand-rolled in_addralias_rtmsg().
This eliminates the following rtsock messages:
Pinned RTM_ADD for prefix (for alias addition).
Pinned RTM_DELETE for prefix (for alias withdrawal).
Example (got 10.0.0.1/24 on vlan4, playing with 10.0.0.2/24):
before commit, addition:
got message of size 116 on Fri Jan 10 14:13:15 2014
RTM_NEWADDR: address being added to iface: len 116, metric 0, flags:
sockaddrs: <NETMASK,IFP,IFA,BRD>
255.255.255.0 vlan4:8.0.27.c5.29.d4 10.0.0.2 10.0.0.255
got message of size 192 on Fri Jan 10 14:13:15 2014
RTM_ADD: Add Route: len 192, pid: 0, seq 0, errno 0, flags:<UP,PINNED>
locks: inits:
sockaddrs: <DST,GATEWAY,NETMASK>
10.0.0.0 10.0.0.2 (255) ffff ffff ff
after commit, addition:
got message of size 116 on Fri Jan 10 13:56:26 2014
RTM_NEWADDR: address being added to iface: len 116, metric 0, flags:
sockaddrs: <NETMASK,IFP,IFA,BRD>
255.255.255.0 vlan4:8.0.27.c5.29.d4 14.0.0.2 14.0.0.255
before commit, wihdrawal:
got message of size 192 on Fri Jan 10 13:58:59 2014
RTM_DELETE: Delete Route: len 192, pid: 0, seq 0, errno 0, flags:<UP,PINNED>
locks: inits:
sockaddrs: <DST,GATEWAY,NETMASK>
10.0.0.0 10.0.0.2 (255) ffff ffff ff
got message of size 116 on Fri Jan 10 13:58:59 2014
RTM_DELADDR: address being removed from iface: len 116, metric 0, flags:
sockaddrs: <NETMASK,IFP,IFA,BRD>
255.255.255.0 vlan4:8.0.27.c5.29.d4 10.0.0.2 10.0.0.255
adter commit, withdrawal:
got message of size 116 on Fri Jan 10 14:14:11 2014
RTM_DELADDR: address being removed from iface: len 116, metric 0, flags:
sockaddrs: <NETMASK,IFP,IFA,BRD>
255.255.255.0 vlan4:8.0.27.c5.29.d4 10.0.0.2 10.0.0.255
Sending both RTM_ADD/RTM_DELETE messages to rtsock is completely wrong
(and requires some hacks to keep prefix in route table on RTM_DELETE).
I've tested this change with quagga (no change) and bird (*).
bird alias handling is already broken in *BSD sysdep code, so nothing
changes here, too.
I'm going to MFC this change if there will be no complains about behavior
change.
While here, fix some style(9) bugs introduced by r260488
(pointed by glebius and bde).
Sponsored by: Yandex LLC
MFC after: 4 weeks
Thus we can use IF_AFDATA_RLOCK() instead of IF_AFDATA_LOCK() when doing
lla_lookup() without LLE_CREATE flag.
Reviewed by: glebius, adrian
MFC after: 1 week
Sponsored by: Yandex LLC
an interface:
- in in_control() skip over not AF_INET addresses.
- in in_aifaddr_ioctl() and in_difaddr_ioctl() do correct check
of address family, w/o accessing memory beyond struct ifaddr.
Sponsored by: Nginx, Inc.
- Host Identity Protocol (RFC5201)
- Shim6 Protocol (RFC5533)
- 2x experimentation and testing (RFC3692, RFC4727)
This does not indicate interest to implement/support these protocols,
but they are part of the "IPv6 Extension Header Types" [1] based on RFC7045
and might thus be needed by filtering and next header parsing
implementations.
References: [1] http://www.iana.org/assignments/ipv6-parameters
Obtained from: http://www.iana.org/assignments/protocol-numbers
MFC after: 1 week
- Remove locking, since all module(9) events are running under &Giant.
- Use TAILQ for protocol handlers and fix a bug which led to
infinite cycle. Bug found in VirtualBox [1]
- Simplify code everywhere.
- Fix documentation.
[1] https://www.virtualbox.org/pipermail/vbox-dev/2013-November/011936.html
PR: 183792 [1]
Submitted by: Valery Ushakov <uwe NetBSD.org> [1]
Sponsored by: Nginx, Inc.
eneough queue space before queuing a bunch of IP fragments.
As the comment in the committed change says, in the post-if_transmit(),
post-SMP, post-preemption world, there's just too much overlapping
concurrent code paths and different approaches to driver transmit
queue management to have this code even remotely be effective.
The only specific place it could be useful is if ALTQ is enabled
but again it doesn't at all promise that all the fragments will be
transmitted anyway.
The main reason for committing this change is to disable a parallel
place where the drops counter is incremented. This is a side effect
of an upcoming change to ixgbe/cxgbe to handle the queue drops
counter slightly better.
Sponsored by: Netflix, Inc.
- The remote host sends a FIN
- in an ACK for a sequence number for which an ACK has already
been received
- There is still unacked data on route to the remote host
- The packet does not contain a window update
The packet may be dropped without processing the FIN flag.
PR: kern/99188
Submitted by: Staffan Ulfberg <staffan@ulfberg.se>
Discussed with: andre
MFC after: never
http://svnweb.freebsd.org/changeset/base/258221
I introduced a bug which initialized global locks
whenever the SCTP stack initialized. This was fixed in
http://svnweb.freebsd.org/changeset/base/258574
by rodrigc@. He just initialized the locks for
the default vnet. This fix reverts to the old
behaviour before r258221, which explicitly makes
sure it is only called once, because this works also on
other platforms.
MFC after: 3 days
X-MFC with: r258574.
In its stead use the Solaris / illumos approach of emulating '-' (dash)
in probe names with '__' (two consecutive underscores).
Reviewed by: markj
MFC after: 3 weeks
In r208160, sctp_it_ctl was made a global variable, across all VNETs.
However, sctp_init() is called for every VNET that is created. This results
in the same global mutexes which are part of sctp_it_ctl being initialized. This can result
in crashes if many jails are created.
To reproduce the problem:
(1) Take a GENERIC kernel config, and add options for: VIMAGE, WITNESS,
INVARIANTS.
(2) Run this command in a loop:
jail -l -u root -c path=/ name=foo persist vnet && jexec foo ifconfig lo0 127.0.0.1/8 && jail -r foo
(see http://lists.freebsd.org/pipermail/freebsd-current/2010-November/021280.html )
Witness will warn about the same mutex being initialized.
Fix the problem by only initializing these mutexes in the default VNET.
option, unbreak the lock tracing release semantic by embedding
calls to LOCKSTAT_PROFILE_RELEASE_LOCK() direclty in the inlined
version of the releasing functions for mutex, rwlock and sxlock.
Failing to do so skips the lockstat_probe_func invokation for
unlocking.
- As part of the LOCKSTAT support is inlined in mutex operation, for
kernel compiled without lock debugging options, potentially every
consumer must be compiled including opt_kdtrace.h.
Fix this by moving KDTRACE_HOOKS into opt_global.h and remove the
dependency by opt_kdtrace.h for all files, as now only KDTRACE_FRAMES
is linked there and it is only used as a compile-time stub [0].
[0] immediately shows some new bug as DTRACE-derived support for debug
in sfxge is broken and it was never really tested. As it was not
including correctly opt_kdtrace.h before it was never enabled so it
was kept broken for a while. Fix this by using a protection stub,
leaving sfxge driver authors the responsibility for fixing it
appropriately [1].
Sponsored by: EMC / Isilon storage division
Discussed with: rstone
[0] Reported by: rstone
[1] Discussed with: philip
o Provide separate functions for SIOCAIFADDR and for SIOCDIFADDR, with
clear code flow from beginning to the end. After that the rest of
in_control() gets very small and clear.
o Provide sx(9) lock to protect against parallel ioctl() invocations.
o Reimplement logic from r201282, that tried to keep localhost route in
table when multiple P2P interfaces with same local address are created
and deleted.
Discussed with: pluknet, melifaro
Sponsored by: Netflix
Sponsored by: Nginx, Inc.
default from the very beginning. It was placed in wrong namespace
net.link.ether, originally it had been at another wrong namespace. It was
incorrectly documented at incorrect manual page arp(8). Since new-ARP commit,
the tunable have been consulted only on route addition, and ignored on route
deletion. Behaviour of a system with tunable turned off is not fully correct,
and has no advantages comparing to normal behavior.
