the page table entry's accessed bit is either preset by the immediately
preceding call to pmap_enter() or by hardware (or software) upon return
from vm_fault() when the faulting access is restarted.
or unmanaged before acquiring the page queues lock. Neither of these
tests require that lock. Moreover, a better way of testing if the page
is unmanaged is to test the type of vm object. This avoids a pointless
vm_page_lookup().
MFC after: 3 weeks
Open Firmware device tree in order to match what the PROM built-in
driver uses. This is especially important when netbooting Fujitsu
Siemens PRIMEPOWER250 as in that case the built-in driver isn't used
and the port facts PortSCSIID defaults to 0, conflicting with the
disk at the same address.
Add missing CURVNET_RESTORE() calls for multiple code paths, to stop
leaking the currently cached vnet into callers and to the process.
Sponsored by: The FreeBSD Foundation
Sponsored by: CK Software GmbH
MFC after: 4 days
that we allow all possible jail IPs as source address rather than
forcing the "primary". While IPv6 naturally has source address
selection, for legacy IP we do not go through the pain in case
IP_HDRINCL was not set. People should bind(2) for that.
This will, for example, allow ping(|6) -S to work correctly for
non-primary addresses.
Reported by: (ten 211.ru)
Tested by: (ten 211.ru)
MFC after: 4 days
addresses while walking the IPv6 address list if in the jail case
something is connecting to ::1.
Reported by: Pieter de Boer (pieter thedarkside.nl)
Tested by: Pieter de Boer (pieter thedarkside.nl)
MFC after: 4 days
by mrinfo and mtrace, was dropped by the IGMP TTL check. IGMP control
traffic must always have a TTL of 1.
Submitted by: Matthew Luckie
MFC after: 3 days
Clearing a page table entry's accessed bit (PG_A) and setting the
page's PG_REFERENCED flag in pmap_protect() can't really be justified,
so don't do it.
first descriptor in TSO case. Otherwise controller can generate bad
frames during TSO. To address it, make sure to pull up ethernet +
IP + TCP header with options in first buffer. Also ensure the
buffer length of the first descriptor for TSO covers entire ethernet
+ IP + TCP with options and setup additional Tx descriptor if the
first buffer includes TCP payload.
Tested by: Amar Takhar <verm <> darkbeer dot org >
MFC after: 1 week
prevents the firmware of Fujitsu Siemens PRIMEPOWER250, which both causes
stray interrupts and erroneously enables interrupts at least when calling
SUNW,set-trap-table, in the foot.
things allows variable length messages to be easily supported.
- Extend KPI with alq_writen() and alq_getn() to support variable length
messages, which is enabled at ALQ creation time depending on the
arguments passed to alq_open(). Also add variants of alq_open() and
alq_post() that accept a flags argument. The KPI is still fully
backwards compatible and shouldn't require any change in ALQ consumers
unless they wish to utilise the new features.
- Introduce the ALQ_NOACTIVATE and ALQ_ORDERED flags to allow ALQ consumers
to have more control over IO scheduling and resource acquisition
respectively.
- Strengthen invariants checking.
- Document ALQ changes in ALQ(9) man page.
Sponsored by: FreeBSD Foundation
Reviewed by: gnn, jeff, rpaulo, rwatson
MFC after: 1 month
- replace modification of pmap resident_count with pmap_resident_count_{inc,dec}
- the pv list is protected by the pmap lock, but in several cases we are relying
on the vm page queue mutex, move pv_va read under the pmap lock
page's PG_REFERENCED flag in pmap_protect() can't really be justified.
In contrast to pmap_remove() or pmap_remove_all(), the mapping is not
being destroyed, so the notion that the page was accessed is not lost.
Moreover, clearing the page table entry's accessed bit and setting the
page's PG_REFERENCED flag can throw off the page daemon's activity
count calculation. Finally, in my tests, I found that 15% of the
atomic memory operations being performed by pmap_protect() were only
to clear PG_A, and not change protection. This could, by itself, be
fixed, but I don't see the point given the above argument.
Remove a comment from pmap_protect_pde() that is no longer meaningful
after the above change.
bd_compat32 field of struct bpf_d is kept unconditionally to not
impose the requirement of including "opt_compat.h" on all numerous
users of bpfdesc.h.
Submitted by: jhb (version for 6.x)
Reviewed and tested by: emaste
MFC after: 2 weeks
do not constitute user-visible or active partitions and as such should
not prevent undoing pending operations.
While here, initialize the last usable sector for the placeholder geom
based on the null scheme, created to allow undoing the destruction of
a scheme. This gives consistent output with "gpart show".
Based on a patch from: "Andrey V. Elsukov" <bu7cher@yandex.ru>
during the grace period after startup. This grace period must
be at least the lease duration, which is typically 1-2 minutes.
It seems prudent for the experimental NFS client to wait a few
seconds before retrying such an RPC, so that the server isn't
flooded with non-recovery RPCs during recovery. This patch adds
an argument to nfs_catnap() to implement a 5 second delay
for this case.
MFC after: 1 week
pmap_ts_referenced() is not always appropriate for checking whether or
not pages have been referenced because it clears any reference bits
that it encounters. For example, in mincore(), clearing the reference
bits has two negative consequences. First, it throws off the activity
count calculations performed by the page daemon. Specifically, a page
on which mincore() has called pmap_ts_referenced() looks less active
to the page daemon than it should. Consequently, the page could be
deactivated prematurely by the page daemon. Arguably, this problem
could be fixed by having mincore() duplicate the activity count
calculation on the page. However, there is a second problem for which
that is not a solution. In order to clear a reference on a 4KB page,
it may be necessary to demote a 2/4MB page mapping. Thus, a mincore()
by one process can have the side effect of demoting a superpage
mapping within another process!
brings in support for an optional intent log which eliminates the need
for background fsck on unclean shutdown.
Sponsored by: iXsystems, Yahoo!, and Juniper.
With help from: McKusick and Peter Holm
physical addresses.
o) Set a local maxmem in sb_machdep.c to avoid trying to use pages over 2^64
under 32-bit ABIs. Our pmap needs corrected to use vm_paddr_t consistently,
then we can make vm_paddr_t 64-bit under 32-bit ABIs and add code in pmap
to limit phys_avail by the maximum PFN that a 32-bit PTE can hold.
Some of these cases should be safe in a non-atomic fashion, however
since all of the driver ioctls are locked, a lot of work is required to
fix it correctly. Just don't sleep now.
MFC after: 2 weeks
