the two GNOME 1-based alternatives.
While here, note that a majority of the items in this menu are not
sentences, and remove trailing dots to make the remainder consistent.
Reviewed by: marcus
Approved by: re (bmah)
of the EFI file system. This makes the EFI partition non-optional.
I don't think that the links are actually correct, given that all
the mount points are under /mnt when sysinstall is run as init.
(ie a non-upgrade). Thus: I think I need to go in once more, but
at least this doesn't get lost...
partitions marked as being of type efi. This change adds code to
1. actually run the newfs command at mount time (install.c),
2. display the newfs state on screen (label.c)
3. allow toggling of the newfs state (label.c)
Even though newfs(8)-ing FAT partitions can be of use on i386
machines in general, it has been opted to minimize impact for
now.
With this change there's no a priori difference between EFI and
FAT partitions. With this change and the corresponding change to
libdisk, we can create EFI partitions, just like regular FAT
partitions.
the loop that runs through the environment variables to be a bit more
intuitive. Also, change some 'continue's in failure cases to 'break's
instead. If we are going to fail, we should just do it.
PR: bin/40654
Submitted by: Thomas Zenker <thz@Lennartz-electronic.de> (partially)
argument as of revision 1.52 (July 12, 1996, about a month after I
graduated from high school) when 'newfs -u' support was axed, so remove it.
This also allows us to remove a hack in the create partition case where we
created the partition twice since we didn't have the size the first time.
- Disabled 'Syscons, Font', 'Syscons, Screenmap' and 'Syscons, Ttys' menus
on pc98.
- Fixed the MenuMouseType and MenuMousePort menus for pc98.
- Fixed some comments for pc98.
something applies to. So change #ifndef to an explicit list of defines.
* Treate sparc64 and ia64 as 64-bit platforms, which means larger roots.
* sparc64 should halt back to the firmware, not reset.
* sparc64 doesn't need to play MS-DOS/BIOS partition crap games.
Reviewed by: jake
one can set the 'noError' variable to ignore any errors that occur for the
next command. However, the code was only unsetting 'noError' when an error
actually occurred, so if you set 'noError', the next command completed ok,
and the command after that failed, the second command's failure would be
ignored. This fixes this by performing the 'noError' check earlier and
then unsetting 'noError' after every command that is run.
Sponsored by: The Weather Channel
